Nissan FJ engine

From All Car Wiki - Car Specification Wiki
Jump to: navigation, search
File:FJ20ET.jpg
FJ20ET engine in the Nissan Engine Museum

The Nissan FJ series engine was a straight-4 DOHC 2- or 2.4 L internal combustion engine produced by Nissan in the 1980s, in 2.4 L guise as a rally motor for the 240RS, and 2.0 L for general production models. The FJ20 weighs 366 lb (166 kg); the FJ24 weighs 368 lb (167 kg). The 2.0 L variant was used in the US110 and US12 Nissan Silvia/Gazelle/Sakura, and DR30 Nissan Skyline. The 2.4 L variant was used in the Silvia based BS110 Nissan 240RS rally car. While a 1.5 L variant was designed and a prototype built, it never actually went into productionTemplate:Citation needed. It is acclaimed by some as the forefather of the CA engine.Template:Citation neededWhile the DOHC CA head is similar, this is actually unlikely, as the SOHC CA was devised as a lightweight replacement for the L/Z series motors when the FJ first entered production, and the DOHC CA head appeared later when the RB series was released. The FJ has an aluminium head, chain driven cams, and an iron block. Turbo motors were only available in Japan and the non turbo variants were available in Japan, Hong-Kong, Australia and Europe. Datsun enthusiasts like to swap FJ engines into L or Z series powered vehicles. The FJ has similar mounting points to L/Z/KA blocks. It was discontinued in the mid 1980s due to its prohibitive costTemplate:Citation needed.It featured large ports,dual valve-springs and a wide angle bucket on shim valvetrain design similar to other (later) Nissan twincams like the VG, CA, RB, and KA, series DOHC motors and the previous S20 6 cyl DOHC motor from the early 1970s GT-R. This valve train design is also found in several motorcycle engines, it has a rev-happy over-square bore/stroke, combined with a stout forged bottom end, and wide bore spacing, the FJ20's strength is legendary .

Contents

Specifications

These engines were developed before Nissan used the D to denote "double over head cam". The FJ is indeed a DOHC 16 valve design with mechanically actuated cam on bucket follower design. The head is aluminium and the block is iron.

FJ20EFJ20ETFJ20ET
With intercooler
FJ24
Total displacement(cc)19902340
bore×stroke(mm)89×8092×88
Compression ratio9.18.08.511.0
Max power/(rpm)150 PS (110 kW; 148 hp)/6000190 PS (140 kW; 187 hp)/6400205 PS (151 kW; 202 hp)/6400240 PS (177 kW; 237 hp)/7200
Max torque(kgf·m@rpm)18.5@480023.0@480025.0@440024.0@6000
Max torque @rpm 181 N·m (133 lb·ft) @4800 225 N·m (166 lb·ft) @4800 245 N·m (181 lb·ft) @4400 235 N·m (173 lb·ft) @6000
The numerical value is gross mark (engine single purpose crankshaft output).
A part of numerical value is different by Skyline and Silvia/Gazelle.
There is a version of the FJ24 with 275 PS (202 kW; 271 hp)

FJ20E

Distinguished by the "E" for "Electronic Fuel Injection". Maximum output was 150 PS (110 kW).

The FJ20E was installed in the DR30 Skyline RS, as well as the US110 and S12 Gazelle/Silvia RS.

FJ20ET

File:LD4C0700.jpg
FJ20ET engine in a R30 Skyline.

"T" denotes turbocharged engine. Maximum output was 190 PS (140 kW) in the R30, and 185 PS (136 kW) in the S12. Boost pressure to achieve this power output was only 6-7 psi. Later intercooled versions produced 205 PS (151 kW) with a slight boost increase.

The FJ20ET was installed in the DR30 Skyline RS/RS-X/RS-X Turbo C and S12 Gazelle/Silvia RS-X; Turbo C versions of the DR30 were intercooled, as well as some S12 RS-X trim cars. The plenum chamber was shortened in the S12 compared with the DR30 because of the smaller engine bay and thus produced slightly less torque and power. However the DR30 plenum can be fitted into the S12 engine bay with very little clearance, and this combination is used by what is currently the fastest S12 Gazelle in the world, a 2,600 lb (1,200 kg) vehicle which ran 9.12 @ 153 mph (246 km/h) in the quarter mile over the standing 400 m.

FJ24

200 or more were produced as a homologation car engine of World Rally Championship at that time according to the Group B regulation. Displacement was expanded to 2340 cc, though it was actually carburated. The FJ24 was installed in the NISSAN 240RS based on the S110 model Silvia. Among 200 total production number, 50 were right-hand drive (RHD), and 150 were left-hand drive, and obtained the Group B recognition of the WRC. 30 were used for the domestic rally championship in the WRC and each country from among the original 200. The number of sales in Japan is uncertain because there is no detailed record though a small number of people bought the original rally cars. Therefore, development was not done in consideration of domestic exhaust emissions regulations.

See also

po:Nissan FJ engine

Three 240 RS came to Guatemala. They coded numbers were 33D, 16E and 77. They were raced at Guatemalan and Central American Championships in 1985 and 1986.
File:Engine FJ24.jpg
Add caption here
File:Starting Grid.jpg
Add caption here

ja:日産・FJエンジン

Personal tools
Namespaces
Variants
Actions
Navigation
Toolbox
Social Networking
Google ads help us out