Nissan H engine
|Predecessor||Nissan G engine|
|Configuration||I4 & I6|
|Cylinder block alloy||Cast iron|
|Cylinder head alloy||
Aluminum (later versions)
The Nissan H series of automobile engines is an evolution of the Nissan "R" engine which was based on the 1.5L 3 main "G" used in the 1960s. Both straight-4 and straight-6 versions were produced, it is a pushrod OHV design with iron block, early models with an iron head, later models with aluminum head. Versions of this motor have been used in many Nissan autos and forklifts, well into the eighties and a version called H20II is still in production today. The SD diesels are based on this series of motors (bore spacing and basic block layout)
The 1H is not related to the later H engines. It was also an all-iron, OHV engine, but with a bore and stroke of 73 and 89 mm it displaced 1,489 cc. Power was 50 PS (37 kW) at 4,400 rpm in 1956, but this increased to 50 PS (37 kW) in August 1958.
- 1956-1960 Nissan Junior B40/42
The basic H is a 1.9 L (1,883 cc) engine produced from 1962 for Nissan's Cedric. Bore was 85 mm (3.3 in) and stroke was 83 mm (3.3 in). The 8.0:1 compression version produced 92 hp (69 kW) and 117 lb·ft (159 Nm), while a high-compression engine (8.5:1) produced 95 hp (71 kW) and 120 lb·ft (163 Nm).
The H20 is the most-common member of the family. Displacing 2.0 L (1,982 cc) thanks to a larger (87.2 mm) bore, H20 engines produced around 99 hp (74 kW) and 123 lb·ft (167 Nm).
- 1966-1968 Nissan Junior 41
- 1966 Nissan Caball C142
- 1967 Nissan Caball C240
- 1968 Nissan Junior 140
- 1966-1972 Nissan Clipper T65
- 1965 Nissan Cedric 130
- 1980-1982 Nissan Urvan
- 1970s Yue Loong Cedric 803 (91 PS/67 kW at 4,800 rpm)
Also N230S, T40, forklifts and other machinery
The R16 motor utilised essentially the same block as the H20, but a shorter piston stroke resulted in a capacity reduction of 387 cc. The R16 was later named a H16. The "R" motor made the switch from 3 to 5 main bearings during its life for improved reliability, and the H20 was developed from this arrangement. The R/H16 bore and stroke is 87.2mm x 66.8mm producing 1,595 cc, 8.0:1 compression, 147 kg/324 lbs +/-90HP
The U20 was similar to the H20 but with an SOHC cylinder head designed by Prince. It was used only in the Datsun Fairlady SR311. The U20 produces 135-150 hp.
The H30 is a 3.0 L (2,974 cc) straight-6 version produced from 1965. Bore was 83 mm (3.3 in), and stroke was a long 100 mm (3.9 in), producing a very undersquare design. Output was a low-revving 120 hp (97 kW) and 173 lb·ft (235 Nm). The H30 is basically an H20 with 2 extra cylinders.
This motor is used in large forklifts